ABN Hole Transfer Punch Set for Steel, Wood, Etc - SAE Transfer Se...

ABN Hole Transfer Punch Set for Steel, Wood, Etc - SAE Transfer Set - 28 Piece Transfer Punch Set 3/32 to 17/32in

Instead of wasting your time by making an inaccurate drill bushing, use the ABN | 28-Piece Transfer Punch Set 3/32-Inch to 17/32-Inch to easily find the center of a threaded, drilled, tapped, or reamed hole. These tools locate the exact spot that your pilot drill bit will start when finding rifle stock screw and bolt holes or even for mandala rock painting. The heat-treated tempered steel construction with black oxide finish prevents rounding, mushrooming, or chipping, and the points are accurately on center. These punches leave a sufficient mark with little force - tap lightly with a hammer to locate the center and then use a center punch to finish the job. Hammer and center punch not included. WARNING: This product can expose you to chemicals which is [are] known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.

• ELIMINATE GUESSWORK: Use the ABN | 28-Piece Transfer Punches Set 3/32-Inch to 17/32-Inch to remove the guesswork of where to place the center punch mark in a hole when transferring dead center from threaded, drilled, tapped, and reamed holes; For toolmakers, machinists, fabricators, and hobbyists to use on metal, wood, and other surfaces; Useful for a tool for die marker or repair, finding rifle stock screw and bolt hole locations, and even rock painting
• PERFECT SIZES: 4-7/8-inch (12.4cm) length of each punch with 0.0025-inch undersize for easy use; Standard imperial SAE sizes include 3/32", 7/64", 1/8", 9/64", 5/32", 11/64", 3/16", 13/64", 7/32", 15/64", 1/4", 17/64", 9/32", 19/64", 5/16", 21/64", 11/32", 23/64", 3/8", 25/64", 13/32", 27/64", 7/16", 29/64", 15/32", 31/64", 1/2", 17/32"
• BUILT TO LAST: Constructed from heat-treated tempered steel with a black oxide finish for maximum strength and longevity that resists corrosion and prevents rounding, mushrooming, or chipping of the conically-shaped (cone) tips; Flat ends are slightly chamfered at the edge; We recommend using these pieces as transfer punches - not intended to take place of a center punch
• EASY TO USE: Select one of the punches, hold punch shaft with one hand while gently tapping a hammer (not included) on the flat top of the punch to make a mark on your selected material that is visible for your center punch, then use your existing center punch (not included) to make a dimple
• PACKAGE CONTENTS: Transfer punch sets package includes (28) transfer punches plus (3/32-inch to 1/2-inch diameters incremented by 1/64-inch, plus a 17/32-inch diameter punch) and (1) 5.25" x 2.5" x 1.6" inch (13.3cm x 6.4cm x 4.1cm) plastic index stand for easy storage (each slot is labeled with SAE sizes for quick identification)